D-TECH 2400 is a highly reliable advanced CLASS-D power amplifier capable of delivering high power over the whole audio band without overheating in a very small size.  At the same time it is capable of reproducing sound with outstanding clarity and stability like never before possible with conventional amplifiers.  

  Unmatched power in a 1U chassis

  High dumping factor even when clipping

  Very stable output at any load
  Short circuit-able speaker outputs
  High quality connectors Neutrik
  AGC for over current protection

  Very high AC voltage tolerance

Sensitivity for full rated power

1.4 Volts RMS or 0.775 Volts

Frequency Response 20 Hz to 20 KHz

1dB   at any power level

Signal to Noise ratio 20 Hz to 20 KHz

More than 103 dB

Total Harmonic Distortion (THD)

0.1%

Intermodulation Distortion (IMD)

0.05%

Dumping Factor

800 From 20 Hz to 400 Hz.

Load Impedance

Safe with all types of loads

Output power stereo mode at  8 ohm      (stereo)

520 + 520 Watts RMS  (both channels driven)

Output power stereo mode at  4 ohm      (stereo)

980 + 980 Watts RMS  (both channels driven)

Output power stereo mode at  2 ohm      (stereo)

1350 + 1350 Watts RMS  ( not recommended )

Output power bridged mode at 16 ohm   (mono)

1040 Watts RMS

Output power bridged mode at 8 ohm     (mono)

1960 Watts RMS

Output power bridged mode at 4 ohm     (mono)

2700 Watts RMS ( not recommended for hot areas )

Overload and short-circuit protection system

Current limited controlled by AGC at 36A per CH.

Overheat protection system

Cut-off  at internal 85 Deg.   Resume at 45 Deg.

Power Supply protection

Soft start - Against all severe voltage fluctuations

AC Input Voltage at full power operation

170 V - 260 Volts AC.

AC Input Voltage at moderate power operation

120 V - 260 Volts AC.

Dimensions W x D x H

480 x 350 x 44 mm  (1U.  19" Rack mount )

Weight 

7.03 Kg.